Anything deeper than that will expose the sprinkler lines. You need to dig only about 6 inches or so. Once you’ve identified the culprit, purchase the correct replacement head.ĭig out a small section of grass and dirt around the sprinkler head to expose the entire piece. Sometimes it’s in an obscure place, and the only symptom is low water pressure for other sprinkler heads. If you run over a spray head with a lawnmower or a car and have used a swing joint the risk of damaging the pipe or fitting in the ground is not really an issue because the material is flexible.Īnatomy Of A Sprinkler Spray Steps To Replace A Spray Headĭetermine which sprinkler head needs replaced. ![]() Another added feature that makes a swing joint appealing is its flexibility and durability. You can always save the incorrectly cut-off nipple for future use… but who needs the clutter. A swing joint allows you more flexibility than a cut-off nipple. Pieces can be cut off using a pipe cutter to allow you to position the spray at the correct height. If the spray body is connected directly to the pipe fitting and the replacement spray body is positioned incorrectly you can add a swing joint to correct the height discrepancy or attach a cut-off nipple.Ī cut-off nipple is a threaded fitting that connects the spray and the pipe fitting on the pipe in the ground. The swing joint is flexible and so you can easily change the height of the spray. If a swing joint is connecting the spray to the pipe much of this will not be of concern. A difference that could, for example, pose a problem when mowing the lawn. replacing a 4″ shrub with a 12″ spray).Įven if you are replacing the spray with the same size spray using a different manufacturer or a different model you still may run across enough of a height difference to cause a problem with the spray’s position in the ground. ![]() If the new spray is taller or shorter than the spray you are replacing it will sit too low or too high in the ground (ex. If your intention is to replace the faulty spray with a different brand, model, or size you may run into problems with the difference in height between the existing spray and the replacement spray. Keep in mind that you need to use the same brand and model to replace the guts or interior contents of the spray body. Instead, dig just slightly deeper than the top section of the spray cap. ![]() Replacing the guts of the spray will eliminate digging the spray completely out of the ground. Simply unscrew the top of the spray head and insert the new spray guts into the existing spray body. Replacing the guts is a quick fix if the casing is not broken and the replacement unit is the exact same model. Note: the same spray brand and model must be used. To replace just the spray guts of your existing spray head, simply unscrew the top of the faulty unit and screw the new spray guts into the existing spray casing. Replace Just the Guts of Your Existing Head To replace the spray with an entirely different spray (model, size, or brand), simply unscrew the entire faulty unit and screw in the new spray model. There are two ways to go about replacing a pop-up irrigation spray head sprinkler either replace the entire spray body or simply replace the guts of the existing spray.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |